How To Set Up Wireless Internet On Windows 7

skip to master content columnskip to horizontal navigation

Help Desk > Networks > Wireless Setup for Windows seven

ETSU wireless access points are bachelor to ETSU students, faculty, and staff. The 2 wireless networks are ETSU and ETSURESNET. If you have a wireless adapter (wireless carte du jour) in your computer, you will be able to connect to the ETSU or ETSURESNET network via a wireless connection. Security for all ETSU Wireless Access Points is enabled by PEAP (Protected Extensible Authentication Protocol).

If yous are trying to connect to an ETSU wireless admission point with your personal computer, please employ the following instructions. These instructions are presuming that Windows is controlling the wireless card. If your computer is using a specific plan to control wireless connections, yous can apply the settings that are provided here to endeavor to configure the programme. ITS cannot provide any specific instructions for setting up a wireless connexion for any wireless configuration programs that may have come up with your car.

Notation: Windows 7 may observe the network and ask yous for your username and countersign. About probable the connection still won't work, even if you provide your correct username and password, until your wireless connection has been properly configured using the steps below

Network list

If you're viewing the list of wireless connections, you can try right-clicking on ETSU. If an option that says "Properties" comes up, you lot can go down to step 5 to finish upward configuring the connexion. Otherwise, use the steps below.

Click on the Start button, go to Control Panel and then cull Network and Sharing Center. If your Control Panel is showing things in Category view, click on Network and Cyberspace and you'll find Network and Sharing Centre in that location. When you lot get there, you should see an option that says Fix upwards a new connection or network.
Choose the Manually connect to a wireless network selection and then click on Adjacent.
Type in ETSU for the Network name, cull WPA2-Enterprise for the Security blazon, and the Encryption type should be set to AES. Leave the Security Key/ Passphrase field blank. Be certain that the box labeled Commencement this connexion automatically is checked. Click on Adjacent.
You'll get a screen that says that information technology successfully added ETSU. At this point, you need to click on Change connection settings. When the next screen comes up, click on the Security tab.
On this screen, be sure that the Security blazon is set to WPA2-Enterprise and that the Encryption type is set to AES. In the box nether Choose a network authentication method:, be certain that it references "Protected EAP (PEAP)". When those are set, click on the Settings push button.
On this screen, you lot need to uncheck Validate server document. Ensure that the Select Hallmark Method is set to "Secured password".
Side by side, click on the Configure push button to the right and uncheck the box as shown below, then click on the OK button.
Click on the OK button to get out of the Protected EAP Properties screen. On the ETSU Backdrop window, click the push near the bottom labeled "Advanced Settings."
Check mark the box reading "Specify authentication mode" and modify the drop-down value to "User authentication." The settings should appear similar to the picture shown here:

Click OK, so click OK again to get out of the ETSU properties screen.
In the lower correct-hand part of the screen near the clock, you should get a notification bubble like this:

Click on that bubble to go the login prompt to announced.
At this screen, simply enter your ETSU username and your password. Click on the OK push.
After a few seconds, your machine should exist connected to the network.